Prusa MINI Enclosure Old PSU holder without Add on PSU

Size:

78mm * 45mm * 160mm ±

Weight:

57g± 19m±

Slicer setting:

• Layer height 0.1-0.2
• Filament PETG(or any) 
• Nozzle 0.4mm
• NO support💢, NO brim💢
• Infill 15%
• Orientation as picture

Prepare(reuse or found in spare):

• M3x8 screw (2x)  
• M3n nut (2x)
• Zip-tie/Fastening tape/Cable tie (1x optional)
• Screwdriver(\_(ツ)_/or you want to your hands)

Step:

• Use one M3 screw, insert it from the back side of the PSU holder to help you insert M3n nuts into each slot, then unscrew it.

• Disconnect printer and move printer out(💀its pain right).
• Release feet bracket so you can insert old PSU in the holder later(if you left the cable outside the enclosure then you can skip this step).

• Release the right side panel(Red arrow pointing) by removing all Nylon rivets and unscrewing M3s(if you are using Transport handle https://www.printables.com/model/921096-mini-enclosure-printable-parts/files Files>Model files>Other) on the right side. 
  • Simple push Nylon rivets tip from inside, once pop out pull from outside and keep push from inside. 

• Move to the back panel and check the bottom left corner. 
• Remove Nylon rivets at marked locations.

• From the inside of the enclosure, insert one M3x8 screws through the left cut-outs(green mark).
• Attach the PSU on the screw.
• Secure the screw, but make sure the PSU holder can still rotate freely(🚩it will touch old PSU a bit so do not over tight).

• Now check the bottom right cut-outs(green mark) and line up with PSU holder M3 slot.
• Insert second M3x8 from the inside of the enclosure.

• Insert old PSU, push it all the way to the end.
• Secure both screws.
• (optional)Tie PSU cable at the bottom of PSU holder(I prefer put all inside enclosure and tie PSU cable inside).

• Put the right side panel back and insert Nylon rivets and M3s(if you are using Transport handle).
• Put printer back and connect the PSU.

Note: feel free to message me for any feedback