Drawer slide rear bracket 60.1890
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A one inch (1") wide rear drawer slide support bracket inspired by the 60.1890 and replaces it.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 58
- Makes
- 0
- Views
- 253
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
I have a house full of cabinet drawers where the rear brackets started breaking. So I drew this 3D model that was inspired from the original bracket that broke. The ideal was to be a drop in replacement that is perhaps a little stronger and more resilient than the original bracket.
This supports a 1" wide by about 3/8" thick drawer slide rail. You may be able to scale it a little bit to adjust it to your needs.
I printed it in PETG, 20% infill and used 4 perimeters to ensure the vertical support piece was solid. Given this is a structural part a case could be made to use no infill but I've found this print parameters adequate for my purposes.
Hope this saves someone some time, effort and few bucks trying to hunt down one of these 30 year old brackets.