Reolink E1 Zoom Stand 8 + 10 cm
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Stand for Reolink E1 Zoom camera with 8 or 10 cm height
- Rating
- 5 / 5
- Likes
- 8
- Downloads
- 81
- Makes
- 3
- Views
- 278
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I use this camera to monitor my 3D printer, but I wanted it to be at least level with the print bed, so I designed this stand.
Available in 8 cm and 10 cm, total height is 11 cm and 13 cm respectively with a diameter of 9 cm. The stand features a cut-out for the power cable and four outlets at the bottom to route the cable in different directions.
I printed the 8 cm version in PLA+ with 15% adaptive cubic infill. Depending on the printer, supports should only be required for the bottom outlets. The print takes approximately 3:15 hours at 0.20 mm layer height and uses about 100 g of filament … the print should not be too light due to the weight of the camera itself.
The 10 cm version takes 30 minutes longer to print and uses 15 g more filament.
Please let me know if you need a lower or higher version of this stand.