Rack Mount Bracket for Netgear GS308PP 8-Port Network Switch
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Strong four piece bracket to mount a Netgear GS308PP on a 19' rack. Printable on A1 mini and Prusa mini.
- Rating
- 5 / 5
- Likes
- 18
- Downloads
- 112
- Makes
- 0
- Views
- 819
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial
This is 19" 1U rack mount bracket for a Netgear 8-port Network Switch (GS308PP). It's pretty beefy because it will be in a portable case and need to stand up to a lot of rough handling. I printed this with PLA on a Bambu Labs A1 Mini, so I designed it as four separate parts. It's assembled with all M3 size screws and feels very sturdy with no sagging in the center.
Printing
My print settings:
- 40% Gyroid Infill
- 5 walls
If it's just going into a rack at home, you can probably get away with lowering both of those settings. The left bracket will probably need small supports but it's for non-visible parts.
Assembly
There are 4 holes to attach the switch from the side, but I ended up only using one on each side. The holes are hard to access and you need a small hex key to get it in. With the bottom screw and one side screw on each side, it feels plenty solid. If you can't get the side screw in, I think it would probably be just fine with the two bottom screws.
Required Hardware:
- (1) M3 x 16mm
- (9) M3 x 12mm
- (4) M3 x 8mm
- (10) M3 x 5.7mm Heat Set Threaded Inserts
See photos for assembly instructions.