1 / 11
ESP32 Camera Holder and articulated arm for installation in an Ikea PLATSA — image 1
1 / 11

ESP32 Camera Holder and articulated arm for installation in an Ikea PLATSA

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Hotch Potch mix of other models and some remixing to make the arm I wanted would fit on any flat service.

Rating
0 / 5
Likes
7
Downloads
42
Makes
0
Views
326
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

I am not sure what to call this model as it is 2 makes and a remix. But I wanted to show the model as a whole in one place, so, A nod to the following two models used to produce my end product as well as remix of the “ESP32 Cam Holder” only of the model shown below.

https://www.printables.com/model/801363-esp32-camera-case

https://www.thingiverse.com/thing:1897363

I was looking for an articulated arm for my ESP32 camera to monitor my printer in a home made printer cabinet using an Ikea Platsa cupboard.

Using Michal Fanta ESP32 camera case as my start point, it took me a day to find the arms that appeared to suit my needs on Thingiverse, described as “tripod arms”. This only left the remixing of the “Cam Holder” to attach the two makes together and to the wall.

A few spare M3 20mm nuts and bolts to connect them all together. I would suggest orientating all the bolts in the same direction to aid future tightening if needed.

Thanks to all for your designs.

 

22/10/24: Added a new “Cam case bottom” with a larger Usb C port. The cable i was using was not quite wide enough and the new cable I purchased did not fit.  It was also stiffer so i have rotated the camera so the cable now comes out of the top as this worked better.

 

 

 

 

 

Tags