Cubitos Rules Lifter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is an addon to the Cubitos boxes to make it easier to lift out the rules
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 10
- Makes
- 0
- Views
- 111
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Board Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an addon to MagnumDanger's Dice Box and Card Display at https://www.thingiverse.com/thing:4809766 and my additional boxes for the Fowl Play expansion at https://www.printables.com/model/997511-cubitos-dice-box-and-card-display-fowl-play-expans, for Cubitos.
Make sure to print it on it's "back" to avoid overhangs.
I keep everything in the Cubitos box like this (see also photos), and unfortunately the rule book is only slightly smaller than the box itself, so it's hard to lift up without picking at it and mangling it. The Lifter sits around one of the boxes on the bottom layer, and allows you to simply lift up the rules (again, see photos).
- (TOP LAYER) remaining boxes + cards
- (MIDDLE LAYER) rulebooks
- (BOTTOM LAYER) boards + some boxes in an "L" shape around them Print Settings
Print instructions
Resolution: 0.2mm
Infill: 15%
Supports: No
Filament: PLA
How I Designed This
I used the existing boxes as a guide to make sure it would fit snugly (but not too snugly) around an existing box, did some other measurements to figure out a good height, and it was otherwise pretty straightforward.