1 / 3
Filament Spool Holder for V-Slot Wheels with 625ZZ Bearings — image 1
1 / 3

Filament Spool Holder for V-Slot Wheels with 625ZZ Bearings

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A filament spool holder you can throw together with the old v-slot wheels from your Ender 3

Rating
0 / 5
Likes
5
Downloads
49
Makes
0
Views
317
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Features

  • Holds a 200mm or 300mm spool.
  • Allows you to upcycle your worn-out Ender-3 625ZZ V-Slot wheels.
  • Can be placed on top of round conduit / bar / pipe using the v-slots of the skates.

Prerequisites

  • 4 x 20mm M5 screws
  • 4 x V-Slot Wheels with 625ZZ bearings
  • 4 x this part
  • (Optional) 4 x flat non-slip rubber/silicone stick-on pads (only if using on a flat/slippery surface)

Print Settings

  • Infill: 15% (not critical, most of the integrity comes from the thicc shell)
  • Layer height: 0.28
  • Perimeters: 5 or more

Instructions

  1. Print the part 4 times.
  2. Thread the smaller hole of each printed part with an M5 tap.
  3. Pair the parts two by two forming two spool holder skates (see rendered assembly).
  4. Place two wheels in each skate.
  5. Insert two M5 screws in each skate, making sure each screw goes as follows:
    1. Through hole of first part
    2. Wheel
    3. Threaded hole of second part
  6. Hand-tighten the screws to avoid stripping the plastic threads.
  7. Optionally stick the non-slip pads to the bottom of the skates.
  8. Place skates on an even surface, or place the v-slots of the skates on top of round conduit / bar / pipe and put a spool on top.

Tags