Case for OpenDTU Fusion Board v2.3
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a case for OpenDTU Vision board v2.3. It has a ventilation grille, Knobs and a light guide for the LEDs.
- Rating
- 5 / 5
- Likes
- 7
- Downloads
- 151
- Makes
- 2
- Views
- 727
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
The case is intended for the OpenDTU Fusion board V2.3. It has pockets for the three antennas and a ventilation grille. Power is supplied via USB-C connector. It has two lids. One is the simple one with the ventilation grille only. The second one adds a light guide for the three LEDs and two knob extensions to operate the RESET and the Boot knob.
I have added the Freecad file, so that you can improve or modify the design on your own.
The Light guide for the LEDs must be printed with transparent PLA and black PLA for the separators. Since I have a AMS in my Bambulab P1S I can print it automatically. The light guide is inserted into the recess in the cover. This is very tight, but because of it I did not need any glue.
The two knob-extensions are very loose in their holes, but this is wanted, since the buttons on the Fusion board do not have a big recoil strength. If the case is closed, they remain at their place.
The labelling is done with the Bambulab Slicer and not with Freecad. Therefore the labelling are not included in the .Step files, but in the .3mf Files they should be available.
Screws for the LID and Board: See last picture.
Have fun.