Samsung Watch Charger Holder Stand T-Clip Ikea Skadis
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A holder for all recent Samsung watches (tested on 5 onwards) using the T-Clip system for boards like the Ikea Skadis.
- Rating
- 4.667 / 5
- Likes
- 22
- Downloads
- 170
- Makes
- 3
- Views
- 686
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A holder for Samsung watches that allows you to charge it in a pegboard like the Ikea Skadis. There are two main models, an original one and a v2 revision which includes the charging cable going all the way down; choose whichever is best for your setup, although the v2 is probably going to be the best option for most people.
Printing instructions
This model should be printed with the T-Clip base perpendicular to the bed and the watch holder touching it. There are some thin lines in the base, so it is recommended to use an adhesion brim; tree supports are necessary for some roofs, but you may use support blockers on most overhangs and bridges if your printer can handle them (which most can).
Use ≤0.15 layer height, 20% gyroid infill, an adhesion brim and tree supports.
Depending on the tolerances of the rubber of your charger's cord, your printer, and spool, you may find that the cable fits too tightly (or not at all) down the holder; a cautionary +0.2 mm margin has been added to the model, but you might have to resort to a pair of pliers to enlarge the radius a few dozens of microns.