Mickey Wall Hook
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I didn't see any good Mickey wall hooks, and we are doing a Disney bathroom, so I designed a wall hook with a Mickey silhouette.
Printing Notes
Recommended to print with ABS, PLA+/ToughPLA or PETG for strength. PLA may not work.
No supports, rafts, or brims needed. (There are 1-2 layers that are about 60 degrees from vertical so depending on your printer, a bit of sanding may be required on the top inside of the hook if it gets a little chunky like mine did.)
30% infill or more recommended for strength and durability.
I printed mine with PETG / 30% honeycomb infill and the hook feels like it can easily support 10-15lbs. You'll probably reach the drywall anchor limit before the hook actually breaks off.
Mounting
Should fit most sizes of drywall anchor screws or wall bolts. A drywall anchor or stud mount is recommended so you don't rip a hole in your wall... who knows what your kids are gonna hang off this thing? :)
Fininshing
Recommended to finish with some type of glossy coating (resin, epoxy, varnish, etc), especially if you hang it up in a bathroom with a lot of moisture.
Category: Organization