Kayak Paddle Grip Index (AKA locater)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An index helps orient the blade into a known position without having to look. Useful when upside down or right way up
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 32
- Makes
- 0
- Views
- 154
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
If you find yourself bracing with the edge of the blade, or rolling with too much or too little angle on the sweep, or perhaps just haven't got a local stockist, then this model should help out.
It's a bit of a work in progress, but fully functional. The uploaded model is scaled to fit on a 235x235mm bed diagonally. Should be easy enough to scale length ways if you have a larger print bed and want a longer index.
This model can be bit fiddly to print as the bottom edges are thin.
I've uploaded two STLs. the -support version has some small tabs to both anchor and support the initial edges. If you're happy to use a brim, then the -nosupport version should be fine.
The -support version may need a light sand after the supports are removed, but it might just be my slicer leaving artefacts
In either case, support is recommended for the overhang.
If you're attaching such that the index is exposed, then I find a very light amount of fuzzy skin when slicing (if you like texture/grip), or sanding it smooth (if you don't), can help.
Adaptive layer heights also help produce a neater print, though thinner layers may produce a weaker print.
I've used 20-30% infill, given the long, thin profile, lower in-fill increases the chances of snapping while removing support.
I've mostly printed them in PETG. TPU also works, and allows for tuning the infill to permit some “squish”. PLA etc should be fine if not exposed to sunlight.
If you have single-part, already constructed paddle, then using glue and/or a tape wrap to attach the index can work. If you're putting an index on a paddle you're assembling, or a two (or more) part paddle, then heat shrink is probably easiest/neatest.
I normally position the index (in line with the back of the control hand blade) and hold it in place with a bit of electrical tape before using some heat shrink, slightly longer than the index, to hold it tightly in position.
