PLAinberger v1 - A 3D printed headless Bass Guitar
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This project was inspired by the Prusacaster 3d printed guitar made by Mikolas Zuza and the iconic 80s STEINBERGER bass
- Rating
- 0 / 5
- Likes
- 41
- Makes
- 0
- Views
- 1,689
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Music
- License
- Standard Digital File License
Demo:
I wanted to design a portable bass that would be inexpensive and at the same time easy to print.
I have a Creality K1 (22x22x25) so can’t print the core of the bass in just one part so had to print in 2. I used 2 40cm 8mm metal rods as internal truss inserts and they have been great in holding the tension of the 2 main core parts.
I also used the lightest gauge string I could find Rotosound RS66LA Swing Bass 66 (30 50 65 85) which are amazing I have always avoided light gauge strings thinking of losing tone but they feel and have great tone.
UPDATES
4/11/2024 Update:
-Added a snap joint option version. The joints are only visible from the back of the bass. New parts are labeled as "Plainberger-wjoints". Parts are oriented to print.
-Added a 9v battery slot option on bottom left side part if you want to go Active. Oriented to print with battery hole facing down (needs supports) .
-Added STP file to allow for easier editing and modifications.
Overview of the pieces:
(an uncut whole body file is also included in downloads)

Hardware
· Bass Neck: I couldn't find a headless bass neck so i got a basic standard bass guitar neck for precision and jazzbass from Pitbul guitars and chopped off the neck with a saw: PBG-BN4M Maple Neck w/Maple Fretboard for JB and PB Style Kits. This part is out of stock.
Here are the measures it had and that I used to make the pocket for it. If yours does not fit this measurments i can happily adjust the pocket for your neck, contact me via printables or send me an email to [email protected].

· Two 8mm 400mm metal rod inserts.
· Bridge ( the part that holds the strings in the top of the neck has really small holes and had to drill bigger size holes to fit the bass strings; it’s the cheapest option you get what you pay for)
Electronics
· Pickups
Printing the parts:
All the parts have been printed in regular PLA. The 2 core pieces have a infill density of 35% and 6 walls. The blue and orange parts are not under the tensile forces so you can play with lower strength settings, i printed them 15% 3 walls. Regular Orca slicer supports where used in the pickup and bridge slots only and not in the rod insert or screw holes.

Assembly
I noticed a slight gap of about 2mm when I joined the two core pieces with the rod. I applied heat from a torch to one end of the rods, allowing them to melt seamlessly and sit securely inside.


Any superglue will work great with PLA try to get a GEL one like the one in the picture which is much easier and cleaner to work with.

Screwing Hardware directly into holes. You want a snug careful fit and avoid overtighting.

New Leg rest & new pickguard
I made an optional flip down leg rest Steinberger style . I used some superglue and inserted 2 screws to secure it. This part prints flat no brim nor supports as it's a print-in-place hinge.