Sliding Cigarette Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A medium, two-part sliding case that holds up to 24 100mm filtered cigarettes
- Rating
- 4.4 / 5
- Likes
- 101
- Downloads
- 1,330
- Makes
- 6
- Views
- 4,588
- Reviews
- 5
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial
A small and convenient case that fits 100mm cigarettes well!
I've included the STL files and use variables almost everywhere to make adjusting the sizing as easy as possible if you want a larger or smaller case, or want to add your own design on the front of it. In most cases you should only need to adjust the number of tubes or the tube diameter/clearance, everything else is calculated based off those numbers.
When printing, it is recommended to lay the inner shell flat and rotate the outer shell upside down. The outer shell may also need a brim, some of my prints failed when not using one.
If adjusting the case, ensure you have the BOSL2 library installed