Yet Another Tofu Press
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple tofupress for smaller 250g packages.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 40
- Makes
- 0
- Views
- 282
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
[Note that even at .12 layerheight, I was having issues with thread engagement. I might revise this model to have a coarser non-standard thread that prints easier.]
A simple tofu press for small 250g packages. Simple drainage slits with a cutout so the tofu does not sit in it's own moisture. Put it on a plate or over a sink drain.
Small enough to fit on a single build plate of an Ender 3 or similar.
No need for extra parts, fully printable.
You can omit the included printable wingnut for a standard M10 wingnut if you want.
The printable wingnut might need some support for the wings, but make sure there's no support in the thread itself. You can achieve this by setting the support angle to 65 degrees or so.
1 x Bottom Part
1 x Top Part
2 x M10 Wingnut
Take the usual food-safety precautions, and make sure to handwash it thoroughly.
Use top layer ironing and thick walls to make it as water-proof as possible.