Polymaker Polydryer Skadis Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A practical mount for the Polymaker Polydryer, meant to be attached to an Ikea Skadis board.
- Rating
- 5 / 5
- Likes
- 75
- Downloads
- 251
- Makes
- 2
- Views
- 1,582
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Here is my second take on a hanger design for the Polymaker Polydryer. I have another design for a different mounting orientation available here. This design takes up less space on the Skadis board while allowing access to the power switch in the back through a cutout. The original plug for the Polydryer is too long to fit into this design. Therefore, an additional 90-degree extension cable to facilitate a proper fit can be purchased HERE. I made my design from scratch in Shapr3D. Includes storage for filament box plugs!
I have not tested this long-term with the dryer running. It feels very sturdy on my Skadis board but may change due to heat from the dryer operation. The hook tolerances are very snug on an original wood finish Skadis, which wiggle into place with general ease.
Please consider supporting if you enjoy this or any of my other models!