1 / 10
Gaggiuino Scales - Filter3 - Atomique Ultra Low Profile Drip Tray — image 1
1 / 10

Gaggiuino Scales - Filter3 - Atomique Ultra Low Profile Drip Tray

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Use this low profile drip tray when brewing with a Filter3 basket to retain scales functionality on Gaggiuino Scales.

Rating
5 / 5
Likes
21
Downloads
95
Makes
2
Views
1,570
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

This is a low profile driptray for use with Scott Rao's filter3 basket on Gaggiuino hardware scales.

There are two versions:

  • Atomique (New!) - the lowest of the low. If your glass can't clear this, take it up with physics.
  • Regular - not as low as Atomique, but you can use the stock tray. Also easier to print.

Most cups and carafes can be inserted and removed without removing the filter3 basket, simplifying the brew process. 

This design also works with most tank risers.

Bill of Materials:

  • 8x - 5mm diameter x 2mm height disc magnets (from Gaggiuino hardware scales BOM)
  • Thin cyanoacrylate glue

filter3 profile modifications:

  • Set stop on weight to 290-315g to end with 365g brewed (22g dose).
    • Remember, there's a lot of water in the basket while brewing.

Model Orientations:

  • Orient bottom surfaces as shown in slicer image. 
  • Print one plate (Atomique or Regular), two inserts

Print settings - Atomique:

  • PETG suggested - logo in center is optional.
  • Tree supports (manual) - Only on large overhung surface, not inside the insert cavity.
  • 0.4mm nozzle
  • 0.2 layer height
  • At least 2 walls
  • At least 30% infill (crosshatch or gyroid suggested)

Print settings - Regular:

  • PETG suggested
  • No supports
  • 0.4mm nozzle
  • 0.2 layer height
  • At least 2 walls
  • At least 15% infill (crosshatch or gyroid suggested)

Assembly Instructions:

  1. Verify magnet orientation on your hardware scales.
  2. Lightly press two (2) magnets into each insert cavity, may be a loose fit depending on printer.
  3. Ensure they are flush with the bottom of the insert.
  4. Glue magnets into place, a small dab of cyanoacrylate glue on each stack will work well.
  5. Glue inserts into tray, ensuring correct orientation relative to hardware scales (the small cutout on the tray faces towards the back). Glue only needs to be placed along walls and flange interface to the tray. The top surface does not contact.

 

Revisions: 

2025.02.26 - Added Atomique Drip Tray without graphic

2024.11.24 - Atomique Drip Tray Release

2024.11.11 - Initial Release

Tags