Toilet charging dock
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€4.63 – €5.66 net (excluding VAT)
For file: toilet phone stand - M4 (3,8mm).gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €5.15 excluding VAT (range midpoint).
- Weight reported by the author
- 88 g
- Print time reported by the author
- 4.02 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
For when you need your number one when doing number two. Phone holder and charging station for when you are 'occupied'
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 20
- Makes
- 0
- Views
- 496
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Share Alike
When was the last time your phone died in your hands?
I know where you were!
And when was the last time you needed to get your wipe on but the episode still lasted 5min?
Start multi tasking today!
And when was the last time you were asked to SIT on the toilet but needed some extra incentive?
Here you go!
Expected a quicky but there was a hefty follow-up?
I've got you covered!
And when was the last time you needed to call somebody because of a lack of paper?
Never forget your phone again!
This will increase the quality of your private time! No more red knees from leaning with your elbows because you need to carry your phone. No more emergency pressure because you have only 1% left.
There is even a warning for when you sit down without your significant other, never bored again!
The model prints without support and I used 3 M4 suction cups that just screw in place. You might want to pre-run the thread with an M4 bolt. Alternatively there is a version for 5mm press in suction cups and a version where you can add your own holes to fit your suction cups.
Happy (organic waste) printing!
- Rossero