DIN Box (with internal rail), for power supply / transformator
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€2.83 – €3.46 net (excluding VAT)
For file: DIN-BOX_0.4n_0.2mm_PLA_MK4SMMU3_1h40m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.14 excluding VAT (range midpoint).
- Weight reported by the author
- 70 g
- Print time reported by the author
- 1.67 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
To hook up a wired (video) doorbell, one needs a transformer. This is a DIN enclosure to fit such a transformer.
- Rating
- 5 / 5
- Likes
- 15
- Downloads
- 131
- Makes
- 0
- Views
- 951
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
This enclosure fits a (video) doorbell transformer that uses a DIN rail. Not always there is enough room left in a fuse box. This box/enclosure, has a 35mm DIN rail inside and has fits a double width DIN module.
You can print it without supports, the overhang will print fine without.
In this example you see a bell-transformer (8,16,24V) that nicely fits inside and clicks firmly to the ‘rail’ at the bottom. Two small holes at the top and bottom (the larger one goes at the bottom), will allow cables to run through. In addition there is a half circle hole at the bottom that allows access to the “spring” that allows (de)attaching of the module.
Two caps can be printed to prevent accidentially accessing the inside.
Print in PLA/PETG or any other material (I printed in PLA and this is strong enough for me) @ 0.2 layer height.