Prusa XL Camera Mount for Ubiquity Unifi g4 flex
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A upper left corner mount to hold the g4 flex camera
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 12
- Makes
- 1
- Views
- 351
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
WARNING - I DO NOT KNOW IF THE ENVIROMENT INSIDE A CLOSED ENCLOSURE IS OK FOR THE g4 FLEX. LET ME KNOW IF ITS A PROBLEM.
You need 3 x 3mm screws and nuts, a single 4mm screw and nut (I used a locking nut) and the correct SAE screw to hold the camera.
Note biggest issue is the 4mm nut MUST be placed properly before you attach the camera THEN you attach to the printer.
If you use a THIN unifi cable you should be able to torture bend it so that it comes out of the camera back and then routes up. Use lots of zip ties to get the cable along the top, down the back and out. The ethernet connecter will not (sadly) pass through the rectangular cable hole even if you remove all the other wires, so don't bother to try. You need to unbolt the enclosure top carefully lift the left side onto a couple of shims while you run the cable out the gap in the back bottom. It's tight but the thin cable makes it. Then remove the shims and reboot the enclosure (4 bolts). BE careful while it's not bolted you don't want to drop it on the floor.