1 / 7
Beacon rev H Probe Rapido HF EVA 3 ducts — image 1
1 / 7

Beacon rev H Probe Rapido HF EVA 3 ducts

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Mount for Beacon rev H probe on EVA 3 HF ducts.

Rating
5 / 5
Likes
2
Downloads
45
Makes
1
Views
367
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

print settings:

  • ABS
  • 270c nozzle
  • 90c bed
  • .15 layer height

Installation/assembly:

  • buy a low profile or better yet an unassembled Beacon rev H probe
    • if you have a low profile version remove the plug from the board
  • solder wire leads to the beacon board
  • solder the other end of the leads to a Through Hole 4 Position 0.079" (2.00mm) socket 
    • make sure you leave enough length on the leads to snap the socket onto the ducts
  • heat shrink the solder joints
  • use m3 heatset nuts
    • for the probe mount you will need to file down the length of the heat sets by 1mm
    • the mount itself is only 4mm thick and the heat sets are 4mm long and if you mount them without shortening they will protrude into the duct
  • snap the socket onto the duct
  • mount the probe
  • make sure the plug clears the left side gantry mount when homing X
    • I've only done this on a vcore 3.1 500 and it was very close but it cleared
  • nozzle offset is X 0, Y 17

Tags