Dual/Double Filament Spoolholder with Skaterbearings for 4040 extrusion
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Dual/Double Filament Spoolholder with Skaterbearings for 4040 extrusion using 608 bearings
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 16
- Makes
- 0
- Views
- 77
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
I needed to mount 4 spools on a 4040 extrusion and did not find anthing to my liking, so i shamelessly remixed this spoolholder as it was fitting for my 1kg spools (70mm) - other bearing spoolholder are too broad - and could be easily adjusted.
The model contains two of those flipped and added a steam (15cm) connected to a 60x40 mounting plate with two central holes for fitting it to a 4040 type extrusion.
Of course it can be screwed to any surface that way - even glueing should not be a problem.
it takes four 608 skater bearings.
The depth is 28mm for stability. If necessary i can recreate with a 20mm deep variant.
Printsettings:
Just lay it flat - it does not strictly need support, but it looks better with. I printed without (some droopy overhangs) but works just fine.