1 / 1
Dual/Double Filament Spoolholder with Skaterbearings for 4040 extrusion — zdjęcie 1

Dual/Double Filament Spoolholder with Skaterbearings for 4040 extrusion

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Dual/Double Filament Spoolholder with Skaterbearings for 4040 extrusion using 608 bearings

Ocena
0 / 5
Polubienia
0
Pobrania
16
Wydruki
0
Wyświetlenia
77
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial

I needed to mount 4 spools on a 4040 extrusion and did not find anthing to my liking, so i shamelessly remixed this spoolholder as it was fitting for my 1kg spools (70mm) - other bearing spoolholder are too broad - and could be easily adjusted.

The model contains two of those flipped and added a steam (15cm) connected to a 60x40 mounting plate with two central holes for fitting it to a 4040 type extrusion.
Of course it can be screwed to any surface that way - even glueing should not be a problem.

it takes four 608 skater bearings.

The depth is 28mm for stability. If necessary i can recreate with a 20mm deep variant.

Printsettings:

Just lay it flat - it does not strictly need support, but it looks better with. I printed without (some droopy overhangs) but works just fine.

Tagi