1 / 8
Drivebay 2.5" SATA Hotswap with Print-in-Place Latching Spring — image 1
1 / 8

Drivebay 2.5" SATA Hotswap with Print-in-Place Latching Spring

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Fully functional hotswap drivebay for 2.5" SATA HDD/SSD. Compatible with usb sata adapter. Locking pin is printinplace.

Rating
0 / 5
Likes
31
Downloads
136
Makes
0
Views
1,172
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Noncommercial

Fully functional hotswap drivebay for 2.5" SATA HDD/SSD. 
Compatible with usb sata adapter. Locking pin is printinplace.

I made this for a larger rack-mount rpi project, so the outside dimensions don't fit any standard 3.5" or 5.25" bays.

The springy locking pin is printed in place and with a little push it comes loose and functions as a spring.

The latch handle both actuates the spring and is used to pull the slider bay from the hotswap slot.

Step file is included. Send a message if you want the F360 sources (but be warned, some of it was scaled from a 3.5" model and is a bit messy ;) ).

 

 

Hardware:

Latch is held in place with 2x 1x6mm metal pins. Could probably use just a piece of wire.

Lock-door is held in place with a M1.6 x 14mm screw

Everything else uses M3 bolts and M3 square nuts.

  • M3x16 for Front panel - bay
  • M3x12 CS for the cage cover

To mount disc in the slider, there are 2 little knobs in one side and 2 screw holes in the other side. So only 2 small M3 screws are needed here.

M3 square nuts are inserted into all the little slots.

Sata adapter: https://www.aliexpress.com/item/1005005187045005.html 

Printing

I recommend printing the outside bay in PLA as it is a bit stiffer than PETG.

The locking door with print in place spring is tuned to work well in PLA.

Everything else can be whatever filament you want.

Supports

Latch should be printed on side with a bit of support.

Slider needs 1mm of support in one end.

The front panel can be printed either face-down with support, or face-up with support on the back side. I prefer the latter, as there is no support material in the locking/latching mechanism.

 

Tags