1 / 2
ptfe compression clip
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Public Domain
I had an issue with MMU unloads completely ‘bypassing’ my filament buffer, going all the way back to the spool and unwinding.
Made this little clip to apply just a bit of resistance to the filament on the ‘spool’ side of the buffer, to encourage the filament to rewind into the buffer instead of continuing on past it.
A couple disclaimers:
- The fusion model is horrible, it's an end result of lots of changes, deletions, etc…for such a simple part, it's a mess.
- Made out of ASA, not sure if PLA would break
- It is nearly impossible to install. Very, very tight fit. Apologies in advance to your fingers.