Mean Well LRS-100 terminal cover (DIN compatible)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Protect power supply terminals
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 15
- Makes
- 0
- Views
- 248
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Features
- Separate AC and DC terminal covers
- AC cover is screwed on
- DC cover is retained by a tab and easily removed
- Standard IEC socket for AC with fuse and switch, same as most printers
- Sized to be compatible with this DIN mount
BOM
- Wires with sufficient gauge
- 4.8mm female quick connectors, spade connectors, ferrules
- IEC socket (see step 4 on which type to buy; or get the one called “AC-05” from here)
- 2in-6out connector (see photos; or get “NC623” from here)
- Voron standard heatset inserts (M3 x 4mm length x 5mm outer diameter)
- M3x6, M3x8 and M2x8 screws (or similar lengths)
Print settings
- 0.2mm layer height
- No supports (there's a small built-in support)
- Recommend PETG
- Recommend printing outer perimeters first for dimensional accuracy
⚠ WARNING This model requires some AC wiring. I'm not responsible for your safety and make no guarantees about this model. Make your own risk assessment. |
Assembly
Step 1
Remove the support (the tiny red part) under the tab on the Base, using flush cutters.

Step 2
Install the 3 heatset inserts

Step 3
Place the power supply on the Base and add the shown M3 screw from outside in.

Step 4
Connect the Live, Neutral, and Ground wires to the IEC socket. Crimp 4.8mm female quick connectors on one end to connect to the socket. Crimp spade connectors on the other end to connect to the PSU.

Step 5
Slide the IEC socket into the AC Cover. It will click in. Connect the wires to the PSU's AC terminals.

Step 6
Place the AC Cover onto the Base and screw it in using the marked screws. The AC terminals of the power supply should be fully covered.

Step 7
Add the 2in-6out connector using two M2 screws. Wire it to the power supply's DC terminals. Crimp spade connectors on the PSU end of the wires, and ferrules on the other end.

Step 8
Slide in the DC cover along the “rail” on the right side of the base. It clicks in and is held in place using the small tab. To remove the cover, you will need to depress the tab, then pull it out.

Finished
