Daisy Button for Giant Snowman Fidget
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Button for 3D Printy's Giant Snowman Fidget. Features a daisy embossed on a button.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 29
- Makes
- 0
- Views
- 207
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Spring & Easter
- License
- Creative Commons — Attribution — Share Alike
For my print, I placed the button face side down onto a smooth PEI plate to give a nice glossy surface finish.
I used Polymaker Polylite Black PLA for the backing; PrintBed French Vanilla for the flower petals; and PrintBed Yellow for the flower center. The backing does overhang; however, I believe the gaps between petals may be too small for supports (I did not try). I set my slicer to print inside to outside to try and provide better overhang performance at the edge of the button.
I did have a small amount of droop from the black filament between petals and the edge of the button, but I probably should have slowed the print down at that layer and/or lowered my hotend temperature.
This was created as a special request and I did not get too many close-up pictures of the button prior to shipping it off, I may add more photos if I can get some after it is delivered. I may create an updated version to extend the petals all the way to the edge of the button to provide better overhang performance to the black filament.