Daisy Button for Giant Snowman Fidget

For my print, I placed the button face side down onto a smooth PEI plate to give a nice glossy surface finish.

I used Polymaker Polylite Black PLA for the backing; PrintBed French Vanilla for the flower petals;  and PrintBed Yellow for the flower center. The backing does overhang; however, I believe the gaps between petals may be too small for supports (I did not try). I set my slicer to print inside to outside to try and provide better overhang performance at the edge of the button. 

I did have a small amount of droop from the black filament between petals and the edge of the button, but I probably should have slowed the print down at that layer and/or lowered my hotend temperature.

This was created as a special request and I did not get too many close-up pictures of the button prior to shipping it off, I may add more photos if I can get some after it is delivered. I may create an updated version to extend the petals all the way to the edge of the button to provide better overhang performance to the black filament.