7cm Nerf Mega XL/MXL dart cutter (super clean cut)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cleanly cuts nerf mxl darts to 7cm length.
- Rating
- 0 / 5
- Likes
- 22
- Downloads
- 88
- Makes
- 1
- Views
- 307
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Share Alike
This is a little different from most other dart cutters I've seen. This comes in two parts, the holder and the cutter. The holder holds the dart (tip down) and the cutter holds a standard utility knife razor blade, then slots around the holder and spins to cut a very clean and precise end onto the dart.
MXL darts in particular are not very accurate, so getting a clean cut on the ends can massively help their stability.
It's also worth noting, 7cm *TOTAL LENGTH* MXL's fit perfectly into standard MXL sillyshells at the correct height to be in line with other sillyshells so they can be loaded in sillyshell magazines, or other blasters requiring exact 8cm shell length.
Printing
No supports, whatever walls, whatever infill.
Usage
RULE #1 IS BE CAREFUL. RAZOR BLADE SHARP. IT CAN CUT FINGERS.
Insert the utility blade into the cutter.
Drop a dart into the holder.

Clip the cutter below the top lip, with the blade above the holder.

Press the tabs on the holder to secure the dart, then spin the cutter PARTIALLY around, then spin it the other direction PARTIALLY, then finally do a full rotation the other direction. This sequence makes sure the cut is very clean. (If you don't care about that just spin it all the way the first time.)

Ta-da your dart is now cut.
Now you can remove the cutter, and drop out the dart. If for some reason the dart is stuck (it shouldn't be) there is a hole on the bottom of the holder to push it out.
Look how clean that cut is!
