Easy to print hose/pipe bend support (parametric)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A parametric bending support for hoses/pipes with holes for mounting screws and easy to print
- Rating
- 5 / 5
- Likes
- 603
- Downloads
- 1,367
- Makes
- 3
- Views
- 5,507
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution
This is probably the easiest to print support for bent pipes and hoses. It's printable without supports. The slightly overarching design lets the hose/pipe snap into place.
Holes for screws (3mm) make mounting to a wall or other flat surfaces easy. Sometimes double-sided tape might be enough to hold it in place. The bottom surface is a bit wider for a good amount of surface contact and easy printing.
The parametric design makes it applicable for a wide range of use cases, such as aquarium hose management or general plumbing in the household. With some modifications it might even be used for cable management ;)
This design is parametric! Go to onshape to customize the design.
Parameters:
hose/pipe diameter
bending angle
bending radius
mounting screw diameter
The wall thickness and other characteristics adjust automatically.
I include here files for a few sets of settings, each with 2 angles: 90 and 180 degree.
Diameter of 10mm with a bending radius of 35mm
Diameter of 12mm with a bending radius of 40mm and 30mm
Diameter of 17mm with bending radius of 60mm (should fit for common washing machine freshwater hoses)
Diameter of 20mm with bending radius of 65mm
Diameter of 24mm with bending radius of 80mm (should fit for common washing machine waste water hoses)
File names follow the scheme D<hose/pipe diameter>-A<bending angle>-R<bending radius>.stl
By popular request I can add stl files for other combinations of settings. Same goes for suggestions for improvements. Feel free to post remixes :)