Oculus/Meta Quest 2 Charging Stand/Dock/Station for Elite Strap With Battery Pack and Controller Holder MK 2

This is a charging dock for the Oculus/Meta Quest 2 and Oculus/Meta Quest 2 Elite Strap with Battery with controller holders MK 2.

There is a two-part base for printing on a smaller build plate like an Ender 3 v2 or others in the Ender 3 series. Make sure to use the USB-C charging cable that comes in the box with your Oculus/Meta Quest 2 or it might not fit in the 3D printed part that holds the cable.

While it is not a necessary step, I added microfiber cloth to mine in all of the spots that the Quest 2 and the controllers touch the 3D print to prevent my Quest 2 and controllers from getting scratched. I would definitely recommend doing this if you have extra microfiber cloth lying around or an old microfiber T-shirt or if you just want to keep your headset pristine. All I did was cut the fabric to be bigger than the part I was putting it on and used a little CA glue (super glue) to secure the fabric to the sides of the print making sure not to put the glue where the Quest 2  or controllers would ever come in contact with it even after it dries. Mine isn’t the prettiest, but I’ve been using it for a while now and it works really well!

If you would like 3D models to use to make accessories for the Oculus/Meta Quest headsets I have two 3D models of the Oculus/Meta Quest headsets and the Oculus/Meta Quest controllers available at the following links:

Oculus/Meta Quest 2: https://www.printables.com/model/868020-oculusmeta-quest-2-3d-scanmodel

Oculus/Meta Quest 3: https://www.printables.com/model/868010-oculusmeta-quest-3-3d-scanmodel

If you like this 3D model please consider leaving a like. I hope you find this 3D model helpful and feel free to leave a comment if you have any questions or comments. If you do end up printing this 3D model please remember to come back to post a make! Happy Printing and Enjoy Everyone!!!