1 / 9
Mounting Brackets (BTC450NP to Fornair 555) — image 1
1 / 9

Mounting Brackets (BTC450NP to Fornair 555)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Mounting brackets to mount the Bestarc BTC450NP plasma cutter to the Forney Fornair 555 Compressor

Rating
0 / 5
Likes
1
Downloads
6
Makes
0
Views
39
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial

Simple L brackets which allow you to mount a Bestarc BTC450NP plasma cutter to the top of the Forney Fornair 555 air compressor. You will need to print two of each part (2x Part A, 2x Part B). Supports might not be required, depending on your printer, but won't hurt either. To limit the height of support and maintain part strength, I would suggest placing the parts on the plate so that the top side edge (one with the smaller hole closer to edge) is facing down [see slicer screenshots]. 

The stock feet on the Bestarc are removed and the screw is reused to mount the new brackets to the plasma cutter . You will need to acquire four M5-1.0x12mm or M5-1.0x20mm socket head cap screws (button head might also work, hex head WILL NOT) to mount the brackets to the compressor. The length needed will depend on whether you decide to keep the rubber feet (you'll need 20mm replacements), or remove the rubber feet and mount directly (reuse stock screws / 12mm replacements). The stock rubber feet mounting screws are 12mm long, while the feet are roughly 12mm overall (with a 2mm inner flange). These are easily found at Ace Hardware, Tractor Supply, Home Depot, or online at places like Zoro, Amazon, Fastenal, and McMaster-Carr. To mount the bracket to the compressor plate, use four M6-1.0x10mm or M6-1.0x12mm socket head cap screws.

 

NOTE: These may work with other models of plasma cutters from Bestarc and other brands, but I haven't tested them. You will need to measure the distance between the centers of the screws on the stock mounting feet. If you get 90mm x 178mm (3.5in x 7in), then these should work.

-----

Printed on an AnkerMake M5C-B using ~79g of Creality CR-PETG (Grey) in 3hr 7min with the following settings [AMStudio]: 0.4mm nozzle, 0.20mm layers, 15% Rectilinear infill @ 45°, 8 layer (walls), 5 layers(top/bottom), Hilbert Curve top layer & Rectilinear bottom layer patterns, tight supports, no brim.

*** I planned on printing at 14 layers for the walls to get a solid part, however the test print I did to check fitment (3 layer wall, 5% infill) was surprisingly strong. Ended up deciding a solid part was not required in this case, if printed properly.

Tags