Magnetic Mani Wand Stand for Magnetic Nail Polish - Mooncat Wand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Stand to hold magnet wands for magnetic nail polish.
- Rating
- 5 / 5
- Likes
- 15
- Downloads
- 123
- Makes
- 2
- Views
- 678
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a modification of my model Magnetic Wand Stand for Magnetic Nail Polish inspired by @HanStudios_2167347's Nail Magnet Holder. This one is based on the dimensions of the magnetic wand from Mooncat, and added another holder in parallel.
This design is intended to function both for velvet and cat eye effects (capable of magnetizing two nails at once for the latter). This stand is designed to use two wand magnets with rectangle magnet size 9X22X4mm (the Mooncat size which is smaller than the HoloTaco and I Scream Nails wand).
The middle of the stand holding the wand stem is designed with a bit of taper at the top so that the wands 'snap' into place and doesn't fly out and snap together. HOWEVER, the cross-section of the stem is slightly oblong, so the wand is easier to take out in the sideways orientation. The magnets should be safely locked in either of the positions shown (either end of the wand fully in the stand).
Also, the tolerances of every printer/material varies so some ways to tweak the fit:
- If it is too tight and threaten to damage the wand, take a file to the tightest spot
- If it is loose, wedge a piece of tape or add thin coats of TC on the inside
Updates:
v2: Added a bit of extra space for the square part of the wand since it is the most likely point of failure if it is too tight a fit.