1 / 2
Rittal 7240.210 powerCON TRUE1 TOP Inlet-Outlet Module — image 1
1 / 2

Rittal 7240.210 powerCON TRUE1 TOP Inlet-Outlet Module

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Add a Neutrik powerCON TRUE1 TOP Inlet-Outlet to your Rittal DK 7240.210 PDU!

Rating
0 / 5
Likes
5
Downloads
23
Makes
0
Views
374
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial

This part replaces the blanking plate in the modular 19" Rittal DK 7240.210 PDU with a module that can hold a Neutrik NAC3PX-TOP inlet-outlet.

Installing it involves removing the fixed cable. Obviously, you can recycle the cable with a powerCON TRUE1 Outlet like NAC3FX-W-TOP or the newer NAC3F-TRUE1-S.

 

DO THIS MODIFICATION AT YOUR OWN RISK! I am not an electrician. If this happens to be the reason your house burns down, I am not at fault. Get an electrician to do it for you or at least to sign off on it. This is not electrical advice. You have been warned.

 

Print settings:

  • 0.2mm Layer height
  • Supports from build plate
  • 3 Perimeters
  • 15% infill is fine
  • Material of your choice. I used PLA, but a more stiff and heat resistant material like PC might be better. YMMV.

Necessary parts:

  • 1 Neutrik NAC3PX-TOP
  • 2 insulated ¼" flat tab terminal crimps (Red)
  • 1 uninsulated ¼" flat tab terminal crimps (Red)
  • 1 WAGO 221-413 for Outlet PE and Chassis PE
  • 4 ruthex RX-M3x5.7 M3 heat inserts
  • 4 counter-sunk M3x10 or M3x8 screws
  • Short PE wire

Necessary tools:

  • Deburring Tool
  • PZ1 screwdriver for opening Rittal 7240.210
  • PH1 screwdriver for mounting Rittal 7240.210
  • Appropriate screwdriver for the M3 screws (Torx or hex!)
  • Wire crimper
  • Wire cutter
  • Wire strippers (if you need them)

 

Instructions for qualified personel only:

  1. Clean up the part, use the deburring tool to remove support and brim if used.
  2. Open PDU side that has the original cable.
  3. Remove blank plate and ensure the 3D print fits!!
  4. Insert the M3 inserts into the 3D print, use NAC3PX-TOP to confirm fit.
  5. Remove cable from terminal block and end piece.
  6. Cut the crimped ends off of the wires coming from the Schuko sockets.
  7. Crimp insulated spades to L and N coming from the sockets.
  8. Wire PE from sockets and chassis ground to 221-413.
  9. Crimp uninsulated spade to short PE wire and attach to 221-413.
  10. Insert printed part and pull spades through.
  11. Insert NAC3PX-TOP into print, ensure wires are properly connected and routed, then fix it with the M3 screws.
  12. Close up with original cable holder end piece (sans cable, obviously)
  13. Perform full electrical safety tests.

Tags