CD / DVD / Bluray Spindle
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€3.48 – €4.25 net (excluding VAT)
For file: DVD Spindle with Screw-on Top_0.2mm_PLA_MK3S_3h53m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.86 excluding VAT (range midpoint).
- Weight reported by the author
- 48 g
- Print time reported by the author
- 3.88 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Parameterized spindle for storing CDs / DVDs / Blurays with a screw-on top to prevent them falling off.
- Rating
- 4.833 / 5
- Likes
- 62
- Downloads
- 918
- Makes
- 9
- Views
- 2,337
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial
This is a parameterized spindle for storing CDs / DVDs / Blurays with a screw-on top to prevent the discs falling off.
It fits all the disc types listed above and has a small bump on the bottom so the bottom disc does not scratch on the base of the spindle.
I printed this spindle in PLA+. However, I think PLA or basically any other non-flex material will be fine as well.
Please post a Make of this print if you liked it and it was useful to you. Thank you!
Customization
I have attached the Fusion 360 design file. You can customize the spindle to your liking. The most relevant parameter, the height of the spindle pin in the middle, is favorited (see screenshot).
The 3mf file provided have a spindle height of 50mm. There are STLs for 75mm and 100mm as well. If you need other dimensions are unable to customize the design yourself, feel free the send me a message.
Print Settings
Material: PLA / PLA+.
Suggested infill percentage: 20%
Layer height: 0.2mm or finer (because of the thread)
Other settings do not really matter.