3D UpFitters RPI4 Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mount an RPI4 on the side of a 3D UpFitters enclosure
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 7
- Makes
- 0
- Views
- 90
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This mount allows one to attach a Raspberry Pi 4 to a 3D Upfitters 3d printer enclosure. This is a base only and is designed to be used with any of the tops based off Malolo’s snap fit design
Attach the unit to your favorite corner using the same screw holes as the support bracket. If you run wires in through the grommet on the left hand side, I suggest the back left corner. If you’re running wires through the grommet on the back, I suggest the back right corner. Should get all the relevant wires pointing the most useful direction.
I’ve been using this for years with no problems.