1 / 2
UBBI Toolhead Filament and sensor Hub
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An remix of UBBI system that allow you to attach the PTFE hub from LH-Stinger allow up to 4 PTFE tube
- Rating
- 5 / 5
- Likes
- 37
- Downloads
- 172
- Makes
- 2
- Views
- 1,649
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This remix combines a LH-Stinger PTFE Hub with an integrated sensor and UBBI system. This modification enables toolhead filaments sensor functionality while maintaining UBBI system compatibility.
Required Parts:
- Adapter Mount (Choose one based on your setup):
- For Stock Neptune 4 Extruder:
- For SilencedFrost 3x5015 Fan Mod:
Print setting:
- PETG, ASA, ABS is highly recommended.
- Print with 0.12 layer hight, 3 wall, 95% infill, No support needed
Installation:
- First print and install the appropriate adapter mount for your setup
- Install the PTFE Hub with sensor
- Connect to your existing UBBI system
BOM:
| Items | Quantity |
|---|---|
| Kailh Red GM 4.0 Microswitch or equivalent | 1 |
| 4mm Ball Bearing (unpack a 608zz) | 1 |
Release Note:
| Version | Note |
|---|---|
| V6 | Lower switch position for more accurate for the top 2 filament lanes. |
| V.2 | Raise bottom wall |
| V.1 | Remove Screw tabs, Optimized filaments flow reduce filament stuck on load/unload. |
| V.0 | Official Release. |