1 / 4
LH Stinger Pico MMU 4x Hub adaptor for Optical Sensor — image 1
1 / 4

LH Stinger Pico MMU 4x Hub adaptor for Optical Sensor

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

adaptation of the new multi-material system to the Neptune 4 Pro

Rating
5 / 5
Likes
17
Downloads
112
Makes
1
Views
994
Reviews
1

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial — Share Alike

Wanted to use the LH Stinger Pico MMU, but use it with my existing setup.   there is no mechanical runout sensor on the machine, so this is an adaptation to use the Optical sensor designed by SilencedFrost.   
 

If using an existing optical sensor setup, open the sensor and remove the PTFE stub instructed when originally installed.    The first time connecting the 2 parts may require a bit of persuasion, similar to the first time installing the ecas04.   A light knock with a hammer worked for me.   To remove, a screwdriver and a light knock with the hammer pops the adaptor off the sensor housing.   After the 1st time joining, the joint loosens up a bit and makes assembly/disassembly much easier. 

Suggest it printed on the back side, (the side without the indents) with support under the single filament throat.    (as shown in the picture)    It can be printed without supports, but tends to get a bit droopy and doesn't fit the sensor filament guide very well.

 

Tags