1 / 4
LH Stinger Pico MMU 4x Hub adaptor for Optical Sensor — zdjęcie 1
1 / 4

LH Stinger Pico MMU 4x Hub adaptor for Optical Sensor

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

adaptation of the new multi-material system to the Neptune 4 Pro

Ocena
5 / 5
Polubienia
17
Pobrania
112
Wydruki
1
Wyświetlenia
994
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Wanted to use the LH Stinger Pico MMU, but use it with my existing setup.   there is no mechanical runout sensor on the machine, so this is an adaptation to use the Optical sensor designed by SilencedFrost.   
 

If using an existing optical sensor setup, open the sensor and remove the PTFE stub instructed when originally installed.    The first time connecting the 2 parts may require a bit of persuasion, similar to the first time installing the ecas04.   A light knock with a hammer worked for me.   To remove, a screwdriver and a light knock with the hammer pops the adaptor off the sensor housing.   After the 1st time joining, the joint loosens up a bit and makes assembly/disassembly much easier. 

Suggest it printed on the back side, (the side without the indents) with support under the single filament throat.    (as shown in the picture)    It can be printed without supports, but tends to get a bit droopy and doesn't fit the sensor filament guide very well.

 

Tagi