Liczymy pasujące modele…
I partially redesigned my lid riser so that after replacing two modules, I could mount a picoMMU. I designed a mount for the picoMMU and a splitter. To make everything work, you still need a runout sensor near the extruder. In this case,…
Mix of the ECAS four lane filament hub and the lightguide of the original Orbiter 2.0 filament sensor.
Alternate servo mount & belt gear for MG90s servo. This servo seems to be more readily available and is quite compatible with EBB42 board given the current and voltage ratings.
Pico MMU with mellow fly-ERCF easy v2. Update1.2 Change -Add heat set insert slot at board mount. Klipper only! Connection USB or CAN BUS Input voltage: DC12V-24V Servo pin P21 Filament sensor P20 Encoder P15 Board information firmware…
*****update 3/20/24 Added a different hub (G2E Hub v16) that loads better than previous. Reshaped the filament hub to fit into the G2E front body ECAS. Added a mount to the G2E front body ECAS for the Pico filament hub to mount.…
Here's a simple mounting bracket mod made with Nick1's gear cover as the base. uses 3x M3x6 screws and T-nuts.
I needed a slightly modified version of the camshaft since i had only smaller bearings at hand. The bearings are for the selector arm (opposite of the drive wheel) and are 7mm instead of the 8mm of the original design. With those smaller…
added the A frame for 4 lanes. I feel it gives more support. Printed the same as Pico parts just because it was already set up
the original used PC4-M6 thread so remix to use PC4-M10/01 thread
This LED mod for the PicoMMU (4-lane) was inspired by @marcribe's model, except it was created from scratch and uses friction fit to stay in place above the lane modules. For the main parts, i recommend Voron settings and ABS/ASA…
This 3-lane hub is a modification of the orginal from LH's github. It adds in space to install an ECAS bowden tube collet to allow for easy mounting to an existing extruder assembly without modifications. In my case it allows me to keep…
Simple bracket that allows to mount PicoMMU on the top of Prusa MK3/MK3S+ frame. The MMU is mounted by the motor with a single M3 screw. Also provides holes to mount EBB42 board under the motor.
