2020 T-Slot attachment to HP DPS-1200FB PSU
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
For using a HP DPS-1200FB power supply as the base to a vertical 2020 t-slot profile
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 11
- Makes
- 0
- Views
- 134
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
The HP DPS-1200FB power supply is quite heavy, so it makes a good base for an electronics prototype jig. The rest of the prototype is built up around a vertical 2020 rail.
BOM
Only if printing the magnet varient,
4x 30x10x2mm magnets
dab of super glue
super glue accelerator makes it go faster
Instructions (standard)
Place the adapter around the power supply
Screw in one or two of the M4 t-nuts to fix the 2020 extrusion into place
Use tape to hold it in place around the power supply. Using tape has the dual purpose of preventing scratches to the desk surface
Instruction (magnet)
Did the bridging cover over the magnets print properly? Great, this is much easier:
Insert the magnets into the print
Place a dab of superglue on each magnet to fix it in
Otherwise,
Remove the bridging cover completely
Spray activator onto the grooves
Apply glue to one pair of magnets.
Install the magnets into one groove, wait for the glue to cure for 2 minutes
Apply glue to the other pair of magnets
Carefully install the magnets into the other groove (they will want to fly out of your hands!)
Wait 10 minutes before placing the adapter around the power supply.
Screw in one or two of the M4 t-nuts to fix the 2020 extrusion into place