1 / 1
2020 T-Slot attachment to HP DPS-1200FB PSU — zdjęcie 1

2020 T-Slot attachment to HP DPS-1200FB PSU

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

For using a HP DPS-1200FB power supply as the base to a vertical 2020 t-slot profile

Ocena
0 / 5
Polubienia
1
Pobrania
11
Wydruki
0
Wyświetlenia
134
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Share Alike

The HP DPS-1200FB power supply is quite heavy, so it makes a good base for an electronics prototype jig. The rest of the prototype is built up around a vertical 2020 rail.

BOM

Only if printing the magnet varient,

  • 4x 30x10x2mm magnets

  • dab of super glue

  • super glue accelerator makes it go faster

Instructions (standard)

  1. Place the adapter around the power supply

  2. Screw in one or two of the M4 t-nuts to fix the 2020 extrusion into place

  3. Use tape to hold it in place around the power supply. Using tape has the dual purpose of preventing scratches to the desk surface

Instruction (magnet)

  1. Did the bridging cover over the magnets print properly? Great, this is much easier:

    1. Insert the magnets into the print

    2. Place a dab of superglue on each magnet to fix it in

  2. Otherwise,

    1. Remove the bridging cover completely

    2. Spray activator onto the grooves

    3. Apply glue to one pair of magnets.

    4. Install the magnets into one groove, wait for the glue to cure for 2 minutes

    5. Apply glue to the other pair of magnets

    6. Carefully install the magnets into the other groove (they will want to fly out of your hands!)

  3. Wait 10 minutes before placing the adapter around the power supply.

  4. Screw in one or two of the M4 t-nuts to fix the 2020 extrusion into place

Tagi