Carbon Monoxide Replacement Bracket / Ceiling Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A replacement and improved bracket for a generic domestic carbon monoxide detector.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 12
- Makes
- 0
- Views
- 55
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A replacement for the factory mount, which the clips/lugs broke off from when replacing the batteries.
Improved with additional mounting holes, countersunk, flat bottomed and more keyhole mounts.
Slots under the “hooks” allow for supports which will be required when printing.
Care is still required when clipping on the detector as the clips are still slim, PLA+ seems fine but with PLA care is needed. With PETG or better then it'll be as good as the factory part.
The only drawback over the factory part, is that the factory part had a slightly hollowed out back, which allows for artexed ceilings a little. This design is printed with the mounting face on the print bed, so its totally flat, so perhaps won't mount well on an artexed ceiling.
Printer: Creality Ender 3 V3 (CoreXZ)
Layer Height: 0.2
Brim: No
Support: Organic on build plate only.
Walls: 4
Top/Bottom: 3 layers
Infill: 25% Gyroid