Laptop Stand - Macbook Pro (Early 2011 - 13 inch)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple angled laptop stand for my Macbook Pro. Wanted a sharper angle to take up less deskroom.
- Rating
- 5 / 5
- Likes
- 23
- Downloads
- 236
- Makes
- 2
- Views
- 1,687
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple angled laptop stand for my Macbook Pro. Wanted a sharper angle to take up less deskroom. Will likely support other laptops -- the gap between vertical supports is 17mm.
Inspired by this design but rebuilt in Tinkercad. I wanted to round out the leading edges and provide additional support to the rear support. Slimmed and widened the base.
Print instructions
Category: Computer Print Settings
Printer Brand: Prusa
Printer: i3 MK3
Rafts: No
Supports: No
Resolution: .3
Infill: 10%
Notes:
Used printer settings inspired by this Makers Muse https://www.youtube.com/watch?v=3kW9SnK4LKc video.
In case it's not obvious, you'll need to print two of these :) Each took about 1.5hr using 'Stupid Fast' settings.