Gridfinity Stand for Feather ESP32 with Reverse TFT
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.96 – €1.17 net (excluding VAT)
For file: adaifruit.feather.reverse.tft_vertical_B_0.4n_0.2mm_PETG_MINIIS_1h10m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.07 excluding VAT (range midpoint).
- Weight reported by the author
- 12 g
- Print time reported by the author
- 1.17 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Gridfinity 1x2x2 base with Stand for Feather ESP32 with Reverse TFT
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 31
- Makes
- 0
- Views
- 411
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
About
I've got two Adafruit ESP32-S3 Reverse TFT Feather and without any enclosure or stand it is a bit inconvenient to use them, especially if you have a lot of other tools on the messy table :D
Thus I mixed gridfinity bin 1x2x2 from the Gridfinity Master Collection with official Feather Stand but due to the license conflict of both models I just dropped both from ‘remix’ and applied more restrictive license from Gridfinity. Later on I added 1x1x3 remix for a vertical mount.
The bin uses standard gridfinity magnets (6x2 or 6x3 mm).
The white two-side enclosure on the Feather is Adafruit ESP32-S2 Reverse TFT Feather Case (there are multiple models).
Please give a like and post makes and provide comments for further improvements.
Changelog
- 2025.01.19 - added vertical models
- 2024.12.26 - initial release, only horizontal and shifted version
Models
- Flat vs with Railing - is smooth and nice but is not that practical if you for example have a LiPo battery, which would slip from it, and thus railing comes in with a help (not on the pictures yet).
- Centered vs Shifted - centered looks nice but USB cable can be a problem, so use a Shifted one.
- vertical A and B - vertical A allows attaching the USB cable from the bottom, and B from the top
Print
- vertical versions (gridfinity 1x1) can be printed without supports, but the magnet holes will be a bit ugly
- horizontal versions (gridfinity 1x2) should be printer with supports
- example photos with Devil Design PETG White, 0.2mm layer, 0.4 height, speed profile.
- gcode just for rough print estimation.