1 / 6
Deej 6 Slider
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Deej enclosures inspired by LTT design, Arduino fits under the sliders
Hardware required:
- 6 sliders
- Arduino Micro
- 20 screws 3x10mm
- 4 screws 3x25mm
- 24 nuts (optional, the screws can screw against the plastic)
- Jumper cables
After assembly, I noticed that:
- A slider is already very stable with only 2 screws
- The top should have 6 screws instead of 4 (it works ok with 4, but 6 would be best)
- The top should have guides for the screws that touch the PCBs because if you tighten them a bit too much, the top will crack