1 / 2
Pelsee P12 Plus Rear view Dashcam mount for BMW F30 — image 1
1 / 2

Pelsee P12 Plus Rear view Dashcam mount for BMW F30

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a custom bracket to replace the OEM BMW F30 mirror (without damaging it) to an upgraded dash cam rearview mirror

Rating
0 / 5
Likes
3
Downloads
30
Makes
0
Views
648
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Noncommercial

This design is intended to use the mounting hardware already on the Pelsee and the BMW mirror mount plate.
To access those screws, you need to scrape off the 4 foam pieces on the back of the unit to access the screws. Then you unscrew those screws and store them somewhere safely. 
 

BMW Mirror removal 


To remove the mirror on my ‘13 BMW 328i xdrive, the mirror used a ball and socket design with a coiled metal ring on the windshield side that needed to be slid off to be able to detach the mirror. I had to use a metal screwdriver and slide it off. Now dont remove the mirror yet since you need to disconnect the eletrical connector. Theres two ways of doing this, either disconnect it by disassembling the mirror, or remove the plastic trim pieces on the windsheild and remove the black connector there. Once disconnected, remove the mirror with some force holding the base and it'll pop off. Slide the connector through the hole in the middle of the ball. 

Now to disassemble the mirror, I used a plastic trim removal piece on the mirror to pop off the plastic frame, you need some decent force but it'll click off. Then remove the mirror and its PCB, remove the four mounting screws with Torx bits and grab the black plate. That black plate is designed to be used with this mount. 

The screws from the BMW plate are too short so I had designed this to use any random screws I can find. That means install two random screws on the top with the mounting bracket as a template to drill the other two holes for another 2 random screws. 

 

Print Settings
 

0.20mm Quality

Filament(longest lasting to temporary): ABS,  PETG, PLA

Infill: 70% 

Supports: None


Installation
 

  1. Once printed, clean up the holes with a small screw driver or allen keys. 
     
  2. Then, screw the Pelsee screws in each corners to fasten your print to the dashcam. Expect a tiny amount of bend to ensure its flush while screwing. 
     
  3. Once thats installed, mount the BMW bracket in the middle with 4 screws. Use the 2 holes in your print to install 2 screws and the other 2 holes in your bracket as a drilling guide. 
  4. Then pop the trim pieces back on and you're ready to roll!
     

Tags