Suzuki Swift key enclosure replacement

Recommended settings tested with Elegoo Neptune 4 Plus printer on PLA material and Orca Slicer: Hot bed first layer 65°C and following layers 60°C. Use 0,4 mm nozzle. Printing temperature 210°C. Infill patterns: Rectilinear. Top and bottom shell layers 8. Sparse infill pattern honeycomb 25%. Speed: first layer 50mm/s, first layer infill 50, outer wall 50, inner wall 80, sparse infill 100, internal solid fill 100, top surface 80, gap infill 80, support default, overhang speed default. Cap part with Suzuki logo faces to hot plate. The logo does not need support. Base part with compartments up. Make manual tree supports about every 4 mm only under the cap around screw hole overhang part and for keyring part of base part. At slicing insert stop at last layer of key base compartment. If you reach this part and printing stops insert metal key top surface cured with build platform glue stick, if necessary heat with lighter before inserting if too tight. Care must be taken to ensure that the key is perfectly aligned with the top layer, otherwise the print nozzle will hit the metal! If necessary, also support the end of the key so that it is aligned with the top layer. Resume printing until ends.