Case for ESP32-CAM for AI-on-the-edge on an Axioma Watermeter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Case for ESP32-CAM to be fixed on an Axioma watermeter. On the ESP AI on the edge software (see GitHub) is operated.
- Rating
- 5 / 5
- Likes
- 5
- Downloads
- 82
- Makes
- 2
- Views
- 947
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
The case is intended to fix an ESP32-CAM module with a camera on an Axioma Watermeter. On the ESP the open source software AI-on-the edge is operated. See GitHub https://github.com/jomjol/AI-on-the-edge-device . The ESP32 can connect to WLAN and send the watermeter-datea via MQTT to Homeassistant. That's how I use this.
For a good and stable recognition rate, the camera shall be fixed very stable on the watermeter. Therefore a case (to remove also light from outside) with fixings is needed.
The model consists of 4 elements:
- Base case (a kind o tube which is set on the watermeter and provides the distance from the LCD display to the ESP32-Camera.
- The LID, which is closing the top of the base case and provides an opening for the ESP32-CAM module PCB
- The PCB Hood which is the fixing the ESP32-CAM on the LID and on the base case
- The bracket which is used to additionally fix the base case on the watermeter. This is done without screws, so the case can be easily removed for a “normal” reading of the LCD on the watermeter.
The screws (M4) for fixing the PCB-Hood and the lid on the base case are screwed into a Ruthex threaded insert (to be melted into the pocket) or with a 4 mm nut fixed on the inside (octagon pocket). I have used the Ruthex threaded inserts because I have them. But I also prepared a pocket for the nut inside the case. Maybe a drop of glue is needed for the nut to keep it at its place.
To fix the ESP32 with camera in its case I have used a bit of elastic foam which I fixed inside the hood on the top side. This gives a bit of pressure to the PCB-stack and keeps the ESP32 PCB at its place.
I have added the Freecad CAD-Drawing file (.FCStd) for remixes and adaptions to the specific situation.
In the parameters spreadsheet you can adjust some values:
e.g. Case_Main_Body_Top_Height which allows you to adjust the height of the camera over the watermeter top surface (LCD).
The sketch “Sketch_PCB” in the body “Body_Base” is the size of the ESP32-CAM PCB (if your module needs adjustments).