Power Strips wall bracket or stand
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€1.03 – €1.26 net (excluding VAT)
For file: Stand_0.3mm_PETG_MK3S_1h7m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.15 excluding VAT (range midpoint).
- Weight reported by the author
- 16 g
- Print time reported by the author
- 1.12 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Bracket for several different power strip sizes. Screw it to a wall or put it in the stand you have the choice.
- Rating
- 4 / 5
- Likes
- 17
- Downloads
- 88
- Makes
- 0
- Views
- 551
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Do you know “Flying” power strips because the cords are too short or clutter on the floor. With this easy to print wall bracket / stand bracket you have a better "home" for a power strip.
Fix it with two or four screws on the wall or place this new version with curved edges, on the stand and place a suitable power strip temporarly in it. I have tested it with different German types of power strips, with this model more power strips will fit. The bracket is fine for a power strip with a height of 42 mm and a width of up to 60 mm. There are so many different sizes of power stripes on the market, please test if it is fine for your model.
Wenn using the bracket, make sure that the plug or power supply is still unobstructed in the power strip, when this is not possible, don´t use this model of wall bracket and design your own. When use a part for electrical devices please note your local code.
I have printed the bracket with PLA. The bracket needs support in some areas, the overhang there is to big. Please have a look at the attached picture (screenshot PRUSA slicer).
The stand do not need support material.
For the design I have used Fusion 360 and the Prusa slicer.