12.7mm Slimline External Disc Drive Enclosure
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€4.82 – €5.89 net (excluding VAT)
For file: Slimline Drive Case_0.4n_0.2mm_PLA_MK4S_3h15m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €5.36 excluding VAT (range midpoint).
- Weight reported by the author
- 111 g
- Print time reported by the author
- 3.25 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
External Drive Enclosure for your Slimline DVD/CD/Disc Reader.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 84
- Makes
- 1
- Views
- 662
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
This is an external slimline disc drive enclosure. It was designed around a 12.7mm Disc Reader out of an old Dell Optiplex, but any Laptop/Small Form Factor 12.7mm DVD/CD Drive will fit. (9.5mm drives may fit too with a bit of ingenuity) The model has a big cutout in the rear to allow basically any Slimline SATA Adapter to work, and it's great for a Living Room PC Setup or use of any unused Slimline Drive you may have sitting around. I also added a few models with various optical disc standards logos, a blank enclosure, and one without feet if you want to add your own or need a very slim enclosure.
If the drive is a bit too loose, you can add a small piece of Electrical Tape to the edge of the drive, and it should result in a snug friction fit. (There are no Screw Holes.)
The model prints with the back on the Print Bed (for less support material) and will work with 15% or more infill. a 0.20mm Layer Height with PLA should work just fine, PETG results may vary.